Please type complete and accurate the model ID specified by manufacturer. No Serial numbers please. Examples: 1998 American Standard / 2011 Strat Deluxe / Les Paul copy / etc.
Right Handed
0.00 USD
Left Handed
8.50 USD
Gold Plated Magnets & Mounting Screws
Gold Plated
+ 42.00
Non-Plated
+ 0.00
Pease Select Plated Magnets & Mounting Screws First
White
Aged White
Black
Parchment
Genuine old 62 relic Strat color
+ 45.00
Surface Finish
Note: These Colors do not accurately represent the actual covers, however are close enough to make a decision on.
Normal Baseplate
+0.00 USD
Parallel Baseplate
+30.00 USD
Get the most out of your new pickups by providing them with optimum electrical environment so they achieve their full sonic potential with our Goodbye-Soldering Harness (DIY Plug-n-Play install kit) where pickups & higher quality controls & wiring are installed fast and easy without any soldering.
To include a KHP-90 harness after this order is added to the CART click ADD ANOTHER PRODUCT and navigate to >Products > Harness >Gibson type ... and ADD TO CART as a separate item.
Please go to the TAB below and choose your Harness model.
Choose For Soldering into your guitar if the pickups are to be connected to stock guitar electrics other than a Kinman Goodbye Soldering Harness that uses miniature plugs.
if in doubt choose the first option since it suits either shielding condition
Cables are long enough for Stock Strats. If you require longer cables state the lengths you require in the ADDITIONAL NOTES box on the Shipping page. Lengths stated below are from the middle of the pickup to the tip of the cable.
neck 250mm (9-3/4") long middle 188mm (7-3/8") long bridge 152mm (6") long
The ground is a separate wire from the Plug and is not shown.
Not all Gibson's have this connector, you need to check inside your guitar. see the image below
Molex 2 wire plug
Molex 5 wire plug
Please indicate what the Bridge pickup is: Humbucker* or P-90 it will have 500k Volume pot load Strat pickups will have 250k Ohm Volume pot load.
NOTE: * Humbuckers can not be split to single coil with this harness. Choose the K9-H instead.
Please indicate what the Bridge pickup are: Humbucker* or P-90 it will have 500k Volume pot load Strat pickups will have 250k Ohm Volume pot load.
Strat pickups require 250k volume pot load. Which positions are for Humbucker or P-90 that require 500k volume pot load.
Is the harness for a rear rout install where the controls are mounted through the wood? Click to see image.
ADDITIONAL NOTES
Note: Check the order details in the panel above and make any corrections because once added to the Cart there is no facility to edits and change order details.
